Genesys User Manual - AMS Neve

Saving a Recall file
In effect, a Recall file is the same as a Snapshot file, so the Save
procedure is the same for both.
▶ On the Monitor Panel, press the SAVE button and the Filing dialogue
will open.
▶ Click Save on screen, and a naming dialogue will open allowing you to
name the Recall file before you save it.
A file name must be unique, and you will be warned if you select a name
already in use.
(The Set As Custom tickbox is not currently implemented).
If you are logged onto Automation, the Recall file will be saved in the
lowest level folder (the Mix folder) for ease of access.
This also means that when Automation folders are backed up to an
archive, they will automatically contain the Recall files associated with it.
▶ Name the file and press Return on the keyboard.
The file will be saved while a screen indicates the progress.
Once it has been saved, a screen will inform you if the operation has been
successful.
▶ Click OK to close.
Replaying a Recall file
▶ On the Monitor panel, press the LOAD button, and the Filing dialogue
will open allowing you to select a Recall file.
▶ Select a file by clicking on it, then click Load.
You will be asked if you wish to load the selected Snapshot.
▶ Click Yes (or Cancel).
The controls that do not need setting manually will automatically be set on
the console (Aux on/off, Aux pre/post etc).
If the console has just been powered up and you have not used Recall on
this session, you will be asked if you wish to start the Recall software
(once you have answered Yes or No, the Recall button will then become
available on-screen for you to start stop Recall as you wish).
▶ Click No, and you will be taken back to the main Genesys screen with
no further action being taken.
▶ Click Yes, and the the Recall software will open.
Ticking the Remember For This Session box means you will not be
shown this dialogue again until the next time the console has just been
powered up.
The Recall button at the bottom of the screen is now available so
Recall can be opened directly without having to go through the Filing
page.
At any point, the Recall software can be stopped and closed by
clicking the Recall button at the bottom of the screen.
There is no confirmation dialogue when doing this.
You will now be shown a screen that shows which controls require
manually resetting on Channel Strip 1 (if there are no controls on
Strip 1 that require resetting, the graphic will show the first
channel strip where this is the case).
- 115 -