Genesys User Manual - AMS Neve

Switchblock
Contains 4 switches, the first three of which should be set as shown left:
Debug:
For AMS Neve use only.
In normal operation, this switch should be in the down position.
Serial:
Enables the communications to be daisy-chained, and must be set to the
up position.
Reset:
For AMS Neve use only.
In normal operation, this switch should be in the down position.
WCK 75Ω:
Set this switch to the up position if you have Wordclock sync coming into
this card. This will terminate the Wordclock input signal. If not, always set
to the down position.
- 133 -