Genesys User Manual - AMS Neve

90Hz filter
Switches a hi pass filter in the channel path with a 90Hz threshold with a
12dB per octave slope.
INPUT TRIM
This supplies +/- 15dB of trim to the incoming Channel signals.
▶ Press the control to cycle the input selection through MIC / LN / DAW /
DLN, shown on the adjacent leds.
NB:
DLN is only available if a Neve FireWire card is present and fitted.
Pans
If you have later LCR channel strips:
L/C/R Pan
Pan control.
▶ Press to enable.
The adjacent led will light yellow if it is set to work as a conventional L/R
pan, or red if set to work as an L/C/R Pan (as set in the Routing Screen).
If this control is not enabled, the Pan control will have no effect on the
audio level that is sent to the routed destinations.
If the Pan is set to work as an LCR Pan and routed to 5.1 destinations (for
example to Left, Centre Right), then there will be 9dB of divergence
between Centre and Left & Right.
For earlier Stereo Pan Channel Strips:
L/R
Pan control.
Classic 3dB centre with S law panning for earlier consoles and 4dB for
later LCR consoles
▶ Press to enable will light yellow only.
▶ If the control is not enabled, the pan control will have no effect on the
audio level that is sent to the routed destinations.
▶ Pans between left and right only.
- 47 -