Genesys User Manual - AMS Neve

CONTROL ROOM MONITOR Section
Sets the monitoring and controls the various sources sent to the
loudspeakers.
AUX 1 – 6
▶ Lights yellow when selected and will send that Aux outputs to the
speakers.
Aux 1-4 to MON L & R, Aux 5 and 6 L & R to MON L & R respectively.
CUE 1 & CUE 2
▶ When selected will light yellow and send that Cue outputs to the
loudspeakers.
MIX
▶ When selected will light yellow and send the Main buss output to the
speakers.
8T
▶ Lights yellow when selected, and sends the 8T mix to the loudspeakers.
The setup to determine which 8T goes to which loudspeaker is done by
either putting the Monitor Panel into Master SEL Mode or from the onscreen
Settings Setup page and using the 8T to MON matrix.
2T
▶ Lights yellow and selects the 2T mixer output to the main monitoring.
Will only work if INT is also selected, and is always interlocked with 8T
even when in Sum mode.
In non-SUM mode, all the above buttons above will be interlocked.
In SUM mode, any combination of the above can be heard.
NB:
The AUX, CUE, MIX, 2T and 8T buttons form the internal monitor
will only be heard if INT is selected, and Externals 1 to 4 will only
be heard if EXT is selected.
EXT 1 & EXT 2
▶ When selected, will light yellow and selects either of the 6-wide External
inputs to the monitor system.
▶ For EXT 2, pressing the button again will light the D-EXT led as well,
so the 2nd set of 6-wide External paths will be taken from the AD/DA
cassette (if present) instead.
All the Externals buttons will interlock unless SUM is selected.
EXT 3 & EXT 4
▶ When selected, will light yellow and select either of the Stereo External
inputs to the monitor system.
Externals 5-20 (Option)
Extra Externals are available (5-20) for monitoring purposes.
- 73 -