You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Momentary Solo mode is<br />
also available.<br />
This is selected by turning<br />
both I/L and Latch Off.<br />
In this mode, a Solo will only<br />
be heard for the length of<br />
time a SOLO button is held.<br />
LATCH<br />
Lights yellow and makes the Monitor, Channel & 8T SOLO buttons latch<br />
within their systems.<br />
NB:<br />
• If LATCH is selected while I/L is selected, then I/L will be<br />
cancelled.<br />
• If LINK is also selected, then MOMENTARY, LATCH and I/L will<br />
operate across Channel & Monitor Solos, but not along with 8T<br />
SOLO (even if 8T Solo has been tied (or not tied) to the Channel<br />
or Monitor Solo in the Settings screen).<br />
RESET<br />
Cancels any active Solos across the console and returns the audio to it's<br />
Pre-Solo'd state.<br />
This includes any combination of PFL & AFL buttons.<br />
LINK<br />
Lights yellow, and makes the 8T (if linked in the Settings screen), Channel<br />
and Monitor systems be linked for Momentary, Interlock and Latch<br />
modes in destructive solo, so that any solo pressed will operate all of the<br />
Monitor or Channel Cuts within the two systems (apart, obviously, for the<br />
Cut selected on that Channel or Monitor).<br />
LINK can only be selected when CH SAFE or MON SAFE are off, and will<br />
be cancelled if either of these two SAFE modes are selected.<br />
DAW SND<br />
Lights red when selected, and is interlocked with DAW RET.<br />
DAW RET<br />
Lights green when selected, and is interlocked with DAW SND.<br />
I/P 2 & DMON led<br />
I/P 2 lights yellow when selected, and toggles I/P 2 and the DMON led<br />
through the following three states:<br />
I/P 2 DMON DAW SND / DAW RTN Availability<br />
1 st press Off Off The interlock between SND and RTN is still available, so you can swap<br />
2 nd press On Off between the two.<br />
3 rd press Off On<br />
The interlock is suspended, and DAW SND will be forced into RTN and<br />
locked.<br />
The I/P 2 and/or DMON leds on each module will also light when these<br />
selections are changed.<br />
NB:<br />
I/P 2 splits away the DAW monitor from monitoring DAW Send<br />
and Return on the channel path (classic in line monitoring) and<br />
gives the DAW monitor a second input to allow for DAW returns to<br />
be brought into the console on the channel path and monitor path<br />
separately, so doubling the mix input capability of the console.<br />
- 65 -
Change language