80C186EC/80C188EC Microprocessor User's Manual

OVERVIEW OF THE 80C186 FAMILY ARCHITECTURE
String instructions automatically update the SI register, the DI register, or both, before processing
the next string element. The Direction Flag (DF) determines whether the index registers are autoincremented
(DF = 0) or auto-decremented (DF = 1). The processor adjusts the DI, SI, or both
registers by one for byte strings or by two for word strings.
If a repeat prefix is used, the count register (CX) is decremented by one after each repetition of
the string instruction. The CX register must be initialized to the number of repetitions before the
string instruction is executed. If the CX register is 0, the string instruction is not executed and
control goes to the following instruction.
Table 2-8. String Instruction Register and Flag Use
SI
DI
CX
AL/AX
DF
ZF
Index (offset) for source string
Index (offset) for destination string
Repetition counter
Scan value
Destination for LODS
Source for STOS
Direction Flag
0 = auto-increment SI, DI
1 = auto-decrement SI, DI
Scan/compare terminator
2.2.1.5 Program Transfer Instructions
The contents of the Code Segment (CS) and Instruction Pointer (IP) registers determine the instruction
execution sequence in the 80C186 Modular Core family. The CS register contains the
base address of the current code segment. The Instruction Pointer register points to the memory
location of the next instruction to be fetched. In most operating conditions, the next instruction
will already have been fetched and will be waiting in the CPU instruction queue. Program transfer
instructions operate on the IP and CS registers. Changing the contents of these registers causes
normal sequential operation to be altered. When a program transfer occurs, the queue no longer
contains the correct instruction. The Bus Interface Unit obtains the next instruction from memory
using the new IP and CS values. It then passes the instruction directly to the Execution Unit and
begins refilling the queue from the new location.
The 80C186 Modular Core family offers four groups of program transfer instructions (see Table
2-9). These are unconditional transfers, conditional transfers, iteration control instructions and interrupt-related
instructions.
2-23