LTV 1100 Operator Manual - CareFusion

Software Version
Use the Software Version option to verify the software version installed in the ventilator. The software
version number is displayed as: VER xx.xx
Usage Meter
Use the Usage Meter to view the time the ventilator has been in use. It is updated every 1/10 th hour
up to 139,000.0 hours and is displayed as: USAGE xxxxxx.x
Communications Setting
The ventilator may be connected to a printer, a graphics monitor, or a modem, or may be set up to
output system diagnostic data. Use the Communications Setting option 39 to select the
communications protocol for data transmission.
Use the MONITOR setting to communicate with an LTM Graphics Monitor.
To modify the Communications Setting:
1) Push the Select button while COM SETTING is displayed.
2) DATA or the currently selected protocol is displayed.
3) Turn the Set Value knob until the desired protocol is displayed.
4) Push the Select button.
Options: DATA, MONITOR, PRINTER, and MODEM
39 Only DATA and MONITOR (for LTM Graphic Monitors compatible LTV ® ventilators) are available at this time.
The MONITOR option is only available when Flow Sensing Patient Circuit mode is enabled (see Chapter 12 –
Operating Procedure for additional information).
21106-001 Rev. E Operator’s Manual - LTV ® 1100 Ventilator 10-15