LTV 1100 Operator Manual - CareFusion

To Remove the Lower Protective Boot 76 :
1) Lay the ventilator down (front up) and use a Phillips-head screwdriver to remove the four flathead
mounting screws and finish washers in the sides of the lower protective boot (2), as
indicated in the illustration.
2) Remove the lower boot (2) and insert and thread four #4-40 X 1/4” flat-head mounting screws (5)
with finish washers (6) into the screw holes in the ventilator’s side panels, as indicated in the
illustration.
Finish washers (6) should be already in place.
3) Torque tighten all four screws to 20 in-oz (0.14 Nm) (do not over tighten to avoid damage to the
finish washers).
Item (1), Protective Boot, Upper (1), P/N 19033-001 (Purple)
Item (2), Protective Boot, Lower (1), P/N 19032-001 (Purple)
Item (3), #4-40 X 3/16” Pan-head screw (1), P/N 10438 77
Item (4), #4-40 X 1/4” Pan-head mounting screws (2), P/N 10435 77
Item (5), #4-40 X 1/4” Flat-head mounting screws (6), P/N 10430 77
Item (6), Finish Washers (6), P/N 19119-002 77
76 Refer to Page C-9 for information concerning the appropriate accessories mounting screws or accessories
replacement screws location, type and length to use when removing or exchanging external accessories on an
LTV ® ventilator.
77 Contained in CareFusion Replacement Screws kit, P/N 11149.
21106-001, Rev. E Operator’s Manual - LTV ® 1100 Ventilator C-5