LTV 1100 Operator Manual - CareFusion

Replacing the Automobile Adapter Fuse
To replace the fuse:
1) Unscrew the knurled nut.
2) Remove the contact point, nut, fuse and spring as shown below. Be careful not to lose the
internal spring, as the adapter will not operate correctly without it.
3) Replace the spring and new fuse as shown.
4) Ensure that the retaining ring is properly in place.
5) Replace the contact point and tighten the nut.
The Universal Power Supply (UPS)
The CareFusion Universal Power Supply kit is a rechargeable external power source and backup
system for CareFusion devices. It has the following features:
AC/DC Converter
Backup Battery Charger
Power and Charge Status LED
Audible and visual alarms to indicate loss of mains power
The Universal Power supply provides an AC derived DC power source which is backed up by a
rechargeable 12 volt sealed lead - acid battery. It can power the ventilator and the graphics monitor.
For more information refer to the UPS Operator’s Manual, P/N 14492.
The SprintPack Li-Ion Power System
The SprintPack is a portable, re-chargeable external power source. It accepts external LTV ® power
sources and has the following features:
Two no-maintenance high capacity HotSwap re-chargeable Lithium Ion batteries providing
up to six hours of mobile power for the LTV ® ventilator.
Ability to act as an Uninterruptible Power Supply (UPS) when an approved power source is
connected and the batteries are fully charged.
For more information about the SprintPack, see the SprintPack Li-Ion Power System Operator’s
Manual, P/N 18415-001.
14-10 Operator’s Manual - LTV ® 1100 Ventilator 21106-001 Rev. E