LTV 1100 Operator Manual - CareFusion

Protective Boot Removal
Supplies/Tools Required:
Replacement Screws Kit, P/N 11149
Torque wrench (20 in-oz / 0.14 Nm to 60 in-oz / 0.42 Nm range)
Phillips-head screwdriver
To Remove the Upper Protective Boot 74 :
1) Carefully place and support the disconnected ventilator in an upright position on a clean, dry
surface.
2) Using a Phillips screwdriver, remove the two flat-head mounting screws and finish washers in
the legs of the upper boot (1) and the two flat-head mounting screws and finish washers in the
sides of the upper boot, as indicated in the illustration on the next page.
3) Remove the upper boot and insert and thread two #4-40 pan-head mounting screws into the
screw holes in the ventilator’s back panel, as indicated in the illustration.
Requires the use of the 1/4” pan-head mounting screw (3).
4) Insert and thread two #4-40 X 1/4” flat-head mounting screws (4) with finish washers (5) into the
screw holes in the ventilator’s side panels, as indicated in the illustration.
Finish washers (5) should be already in place.
5) Torque tighten the mounting screws to these specified values (do not over tighten to avoid
damage to the finish washers);
Torque tighten the screws in the back panel of the ventilator to 60 in-oz (0.42 Nm)
Torque tighten the screws in the sides of the ventilator to 20 in-oz (0.14 Nm)
74 Refer to Page C-9 for information concerning the appropriate accessories mounting screws or accessories
replacement screws location, type and length to use when removing or exchanging external accessories on an
LTV ® ventilator.
21106-001, Rev. E Operator’s Manual - LTV ® 1100 Ventilator C-3