LTV 1100 Operator Manual - CareFusion

Symptoms Possible Causes What to Do
Ventilator gets
excessively hot.
Ventilator does not
work with LTM
Graphics Monitor.
Patient circuit leaks.
ventilator must run
harder to maintain
PEEP.
Internal problem with
the ventilator.
Communications
setting is not set to
MONITOR mode.
Ventilator requires
upgrades to be
compatible with LTM
Graphics Monitor.
Ventilator running in
Non-Flow Sensor
Patient Circuit Mode.
Defective connections
between the LTM
Graphics Monitor and
the ventilator.
Perform a Leak Test and reseat or replace the
leaking parts or connections. See page 11-8 for
instructions.
Immediately contact a certified CareFusion
service technician.
Set communications setting to MONITOR mode.
See page 10-15 for instructions.
Check LTM compatibility in the Model Number
menu. See page 10-18 for instructions.
If the ventilator is not LTM compatible, it will
require upgrading by a certified CareFusion
service technician to accommodate the LTM
Graphics Monitor.
Verify ventilator is running in Flow Sensor Mode
(see Chapter 12 – Operating Procedure for
additional information).
Check the Communications Data Cable
connection between the ventilator’s
communications port and the LTM Graphics
Monitor’s Data Port. See the LTM Graphics
Monitor Operator’s Manual, P/N 11010, for
detailed instructions.
21106-001 Rev. E Operator’s Manual - LTV ® 1100 Ventilator 15-13