LTV 1100 Operator Manual - CareFusion

EMC and RF Environments
The following tables are provided in compliance with 60601-1-2 © IEC:2001(E), and describe the
tested EMC limitations of the LTV ® Ventilator used with the LTM Monitor, LTV ® SprintPack and
LTV ® AC Adapter. 63
Table 201 - 60601-1-2 © IEC:2001(E)
Guidance and manufacturer’s declaration – electromagnetic emissions
The LTV ® Ventilator is intended for use in the electromagnetic environment specified below. The customer or the user
of the ventilator should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
Group 1
Class B
Class A
Complies
The LTV ® Ventilator uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The LTV ® Ventilator is suitable for use in all establishments, including
domestic establishments and those directly connected to the public
low-voltage power supply network that supplies buildings used for
domestic purposes.
63 The use of power supplies or accessories other than those listed may result in increased emission or
decreased immunity of the ventilator. The ventilator should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, observe and verify normal operation of the ventilator in the
desired configuration.
A-10 Operator’s Manual - LTV ® 1100 Ventilator 21106-001 Rev. E