LTV 1100 Operator Manual - CareFusion

More documents

Recommendations

Info

Oxygen will be applied through the low pressure, low flow inlet. Use this chart to determine the approximate O 2 flow required to deliver the desired FIO 2 . WARNING Inspired Oxygen (FIO 2 ) Concentration – If the patient has a variable respiratory rate, his/her minute ventilation will fluctuate. If exact concentrations of inspired oxygen (FIO 2 ) are required to be delivered to the patient, it is recommended that an accurate oxygen analyzer with alarms be used. AVERTISSEMENT Concentration d’oxygène inspiré (FIO 2 ) – Si la fréquence respiratoire du patient est variable, sa ventilation-minute va fluctuer. Lorsqu’une concentration exacte d’oxygène inspiré (FIO 2 ) est nécessaire pour une transmission au patient, il est recommandé d’utiliser un analyseur de niveau d’oxygène précis, comportant des alarmes. 21106-001, Rev. E Operator’s Manual - LTV ® 1100 Ventilator C-13
Low Pressure O 2 Source (cont.) To determine the required O 2 input flow: 1) Find the desired FIO 2 (bottom of chart). 2) Calculate the patient’s minute ventilation rate by using the following formula: Tidal volume x breath rate. 3) Follow the FIO 2 up to the applicable slanted VE (minute volume) line (right side of chart). 4) Read across horizontally to the left side of chart to the required Input O 2 Flow (lpm). To determine the delivered O 2 concentration: 1) Find the Input O 2 Flow (left side of chart). 2) Follow the Input O 2 Flow across horizontally to the right to the applicable slanted VE (minute volume) line. 3) Read down to the FIO 2 (bottom of chart). C-14 Operator’s Manual - LTV ® 1100 Ventilator 21106-001 Rev. E
Page 1 and 2:
LTV ® 1100 Ventilator Operator’s
Page 3 and 4:
Warranty CareFusion warrants that t
Page 5 and 6:
Notice To Operators Unsafe Operatio
Page 7 and 8:
Breath Rate .......................
Page 9 and 10:
High Pressure Alarm Delay .........
Page 11 and 12:
Installation and Setup ............
Page 13 and 14:
Operator’s Safety Information All
Page 15 and 16:
WARNING Battery run time - When the
Page 17 and 18:
AVERTISSEMENT Personnel non qualifi
Page 19 and 20:
AVERTISSEMENT Modes Vérification e
Page 21 and 22:
Cautions CAUTION Ventilator Sterili
Page 23 and 24:
CAUTION External Battery Pack - The
Page 25 and 26:
ATTENTION Nettoyage du panneau fron
Page 27 and 28:
Symbols Symbol Compliance 1 Title A
Page 29 and 30:
Indications for Use The LTV ® 1100
Page 31 and 32:
Information/Assistance For addition
Page 33 and 34:
Volume Control Breaths For Volume C
Page 35 and 36:
Spontaneous Breaths For Spontaneous
Page 37 and 38:
SIMV Mode SIMV mode is selected whe
Page 39 and 40:
NPPV Mode The ventilator provides N
Page 41 and 42:
Volume Ventilation The LTV ® 1100
Page 43 and 44:
Setting a Control There are 5 kinds
Page 45 and 46:
Bright, Dim and Blank Control Displ
Page 47 and 48:
Control Locking The front panel con
Page 49 and 50:
Breath Rate Use the Breath Rate con
Page 51 and 52:
High Pressure Limit Use the High Pr
Page 53 and 54:
Low Pressure The Low Pressure alarm
Page 55 and 56:
On/Standby This button switches the
Page 57 and 58:
PEEP Control The PEEP control estab
Page 59 and 60:
Select Use this button to change th
Page 61 and 62:
Set Value Knob Use the Set Value kn
Page 63 and 64:
Tidal Volume Use the Tidal Volume c
Page 65 and 66:
6-18 Operator’s Manual - LTV ® 1
Page 67 and 68:
Battery Level The Battery Level ind
Page 69 and 70:
Charge Status The Charge Status ind
Page 71 and 72:
NPPV The NPPV 20 indicator LED is l
Page 73 and 74:
Automatic or Manual Data Display Sc
Page 75 and 76:
I:Ecalc xx:xx The Calculated I:E ra
Page 77 and 78:
Alarms APNEA, APNEA xx bpm When the
Page 79 and 80:
BAT EMPTY (cont.) NOTE When the bat
Page 81 and 82:
BAT LOW (cont) NOTE Internal Batter
Page 83 and 84:
DEFAULTS (cont.) The factory-set de
Page 85 and 86:
DISC/SENSE When the ventilator dete
Page 87 and 88:
HIGH PEEP When the patient circuit
Page 89 and 90:
High PRES (cont.) The HIGH PRES ala
Page 91 and 92:
INOP An INOP alarm is generated whe
Page 93 and 94:
LOW PEEP When the patient circuit p
Page 95 and 96:
NO CAL DATA, NO CAL Monitor Display
Page 97 and 98:
POWER LOW When the ventilator is op
Page 99 and 100:
RESET / RESET 1 A RESET or a RESET
Page 101 and 102:
SBT > f When the Spontaneous Breath
Page 103 and 104:
SBT > f/Vt When the Spontaneous Bre
Page 105 and 106:
XDCR FAULT When a transducer autoze
Page 107 and 108:
H&L PEEP OFF The H&L PEEP OFF messa
Page 109 and 110:
LO f/Vt OFF The LO f/Vt OFF message
Page 111 and 112:
SBT TIME The SBT TIME message is di
Page 113 and 114:
Navigating the Extended Features Me
Page 115 and 116:
Apnea Interval Use this menu item t
Page 117 and 118:
Patient Assist Use the PNT ASSIST m
Page 119 and 120:
Variable Rise Time Use the Variable
Page 121 and 122:
Variable Time Termination Use the V
Page 123 and 124:
Leak Compensation Use the Leak Comp
Page 125 and 126:
Control Unlock Use the Control Unlo
Page 127 and 128:
Set Date Use the Set Date option to
Page 129 and 130:
PIP LED Use the PIP LED option to t
Page 131 and 132:
Sigh Breath Use the Sigh Breath fea
Page 133 and 134:
Turning Leak Test Query on or off 1
Page 135 and 136:
SBT Operations (cont.) When the Spo
Page 137 and 138:
SBT Quick Start Feature In addition
Page 139 and 140:
Bi-directional Flow Transducer Diff
Page 141 and 142:
Real Time Transducers Use the Real
Page 143 and 144:
10-32 Operator’s Manual - LTV ®
Page 145 and 146:
To enable the Ventilator Checkout m
Page 147 and 148:
Display Test Use the Display Test t
Page 149 and 150:
Control Test Use the Control Test t
Page 151 and 152:
Leak Test Use the Leak Test to test
Page 153 and 154:
Vent Inop Alarm Test Use the Vent I
Page 155 and 156:
Exit To exit the vent check mode an
Page 157 and 158:
AVERTISSEMENT Mode de circuit du pa
Page 159 and 160:
The Power On Self Tests 43 (POST) a
Page 161 and 162:
Procedure for Control Mode Set Up S
Page 163 and 164:
Procedure for SIMV Mode Set Up Set
Page 165 and 166:
Procedure for NPPV Mode Set Up Set
Page 167 and 168:
LTV ® Ventilator Settings Checklis
Page 169 and 170:
Cleaning or replacing the Fan Filte
Page 171 and 172:
Cleaning the Exhalation Valve and R
Page 173 and 174:
ATTENTION Nettoyage du piège à ea
Page 175 and 176:
To clean the exhalation valve, sens
Page 177 and 178:
Page 179 and 180:
Using the AC Adapter To run the ven
Page 181 and 182:
2) Connect the power connector on t
Page 183 and 184:
Using the Automobile Cigarette Ligh
Page 185 and 186:
CAUTION Release Button - To avoid d
Page 187 and 188:
Replacing the Automobile Adapter Fu
Page 189 and 190:
Page 191 and 192:
Displays and Buttons Some of the sy
Page 193 and 194: Symptoms Possible Causes What to Do
Page 195 and 196: Ventilator Performance Symptoms Pos
Page 203 and 204: Power and Battery Operation Problem
Page 205 and 206: Alarms Many alarms such as HIGH PRE
Page 215 and 216: 15-26 Operator’s Manual - LTV ®
Page 217 and 218: Control Range Tolerance Tidal Volum
Page 219 and 220: Fixed Alarms Control Range Toleranc
Page 221 and 222: Displays Display Range Tolerance Ai
Page 223 and 224: Power Feature Range Tolerance / Ind
Page 225 and 226: EMC and RF Environments The followi
Page 227 and 228: Table 203 - 60601-1-2 © IEC:2001(E
Page 229 and 230: A-14 Operator’s Manual - LTV ® 1
Page 231 and 232: Service Assistance For assistance i
Page 233 and 234: Protective Boots Rubberized protect
Page 235 and 236: Item (1), Protective Boot, Upper (1
Page 237 and 238: Protective Boot Installation Suppli
Page 239 and 240: To Install the Lower Protective Boo
Page 241 and 242: Patient Breathing Circuit - Connect
Page 243: Low Pressure O 2 Source This option
Page 247 and 248: Communications Port The Communicati
Page 249 and 250: 3) If the remote alarm has a male B
Page 251 and 252: Ventilator Settings and Procedure P
Page 253 and 254: Procedure: Set the Low Min. Vol. al
Page 255 and 256: Ventilation flow enters the Flow Va
Page 257 and 258: 5) Push the Select button. xx:even
Page 259 and 260: Code Event Name Event Associated Al
Page 261 and 262: Event Codes by Event Name Event Nam
Page 263 and 264: Event Name Code Event Associated Al
Page 265 and 266: TERM Control mode CPAP CPAP mode Di
Page 267 and 268: TERM Pressure support breath Pressu
Page 269 and 270: C Calculated Peak Flow · 6-16, 8-2
Page 271 and 272: NPPV Mode · 4-4, 10-11 Indicator
show all

LTV 1100 Operator Manual - CareFusion

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?