LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
C Bit 140
C Bit 141
C Bit 142
C Bit 143
C Bit 144
C Bit 145
C Bit 146
C Bit 147
Description:
2nd +X Axis Software Limit Choice
2nd -X Axis Software Limit Choice
2nd +Y Axis Software Limit Choice
2nd -Y Axis Software Limit Choice
2nd +Z Axis Software Limit Choice
2nd -Y Axis Software Limit Choice
2nd +4th Axis Software Limit Choice
2nd -4th Axis Software Limit Choice
1 st software limit: Using parameter 1006 ~ 1013 to set the limit. After executing zero return
procedure, the parameter setting value will be enabled. The booting default
value of +ive direction is 99999.999mm and the booting default value of –ive
direction is -99999.999mm.
2 nd software limit: Using parameter 1034 ~ 1041to set the limit. After executing zero return
procedure, the parameter setting value will be enabled. The booting default
value of +ive direction is 99999.999mm and the booting default value of –ive
direction is -99999.999mm.
The corresponding C BIT of each axis can exchange any value between the 1st software limit
and the 2nd software limit. This means that only one set/combination can be enabled at tone
time within the limit of the 1 st software limitation and the 2 nd software limitation.
Software Limit
C BIT
X axis +ive direction C140: When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
X axis -ive direction C141: When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
Y axis +ive direction C142: When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
Y axis -ive direction C143:When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
Z axis +ive direction C144:When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
Z axis -ive direction C145:When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
4th axis +ive direction C146:When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
4th axis -ive direction C147:When OFF, use 1 st software limit;
software limit
When ON, using 2 nd software limit.
X axis Moving Range (C140
X axis Moving Range
(Para. # 0071 is 1、C129 is ON)
X axis Moving Range(C140 OFF)
X axis Moving Range
(Para. # 0071 is 1、C129 is OFF)
+X
+ X axis
1 st soft limit
G22 travel limit: Able to designated the embedded travel checking range. For Internal and
- X axis
Direction G22
+ X axis
Direction G22
LNC Technology Co., Ltd. 95