LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Machine Adjustment
7.2 Laser Compensation Procedure
R(MAC Coord.)
1
-X
2
3
4 5
Total Length = ABS(Q) * K
K+3
Arg. U to Decide Effective or Not
K+4
E(Cancel Distance of Backlash)
Q(Each Section Measurement)
K+5
2K+5
K+7
K+6
:Repaidly Ori. G00
E(Cancel Distance of Backlash)
:Linear Inter G01
:Pro. Pause M0
:Stop G04
:Pro. Finish
Program Argument Description
1. A:Axis direction, 1 means X axis, 2 means Y axis and 3 means Z axis.
2. E:Delete backlash moving distance. If it is a positive value, at beginning of
measuring, the program should move ABS(E)distance toward this axis
positive direction. Then moving ABS(E)distance toward negative direction
(Step 2 and Step 3 from the above Diagram). After measuring forward direction,
first moving ABS(E)distance toward negative direction and then moving ABS
(E)distance toward positive direction (Steps K+4 and K+5 from the above
diagram). If it is a negative value, then using the opposite method. So, if this
axis pitch error compensation direction is positive, then this argument must be
set as negative value. If it is a negative direction compensation, then this
argument must be set as positive.
LNC Technology Co., Ltd. 283