LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Appendix B: Servo Connection Example
Parameter Function Setting Range
typ
Standard setting
mode selection
1:50Hz standard setting
2:60Hz standard setting
3:Factory default setting
4:Trip history clear
5:Comulative operation time clear
6:Type information clear
7:User setting storage
8:Reset to saved parameters (7)
Setting
Value
Parameter Function Setting Range
Setting
Value
Fr Forward / reverse run 0:Forward run 1:Reverse run 0
selection
This parameter is effective when CNOD is 1.
In hardware wiring of F-CC: Forward running. R-CC Wiring: Reverse running. Please also refer
to parameter F105.
Parameter Function Setting Range Setting Value
ACC Acceleration time 1 0.1(Note) ~ 6000 seconds Recommending
Value = 15
DEC Deceleration time 1 0.1(Note) ~ 6000 seconds Recommending
Value = 15
(Note) If the setting time is very small, it can be set by Para. F508. The range is 0.01 ~
10 sec.
The ACC time is the frequency value of Output Speed Commanding, which is the time of
frequency from 0 adding up to FH setting value.
The DEC time is the frequency value of Output Speed Commanding, which is the time of
frequency from FH decreasing down to 0 setting value.
If two parameters are to set AU1 as 0, then it is manual adjustment parameter. Please refer
to Figure 3 as a constant acceleration/deceleration frequency changes example.
Acc/Deceleration are Constant No Matter Any Change
FH
Time
Acceleration Time
Deceleration Time
Figure 3
Parameter Function Setting Range
Setting
Value
328 LNC Technology Co., Ltd.