LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
S Bit 016
S Bit 017
S Bit 018
S Bit 019
Description:
X 1st Axis Point Return End
Y 1st Axis Point Return End
Z 1st Axis Point Return End
4th 1st Axis Point Return End
When these signals are ON, it means the system relative axis completed the zero return
procedure and stop at the zero point.
S Bit 020 X 2nd Axis Point Return End
S Bit 021 Y 2nd Axis Point Return End
S Bit 022 Z 2nd Axis Point Return End
S Bit 023 4th 2nd Axis Point Return End
Description: When these signals are ON, it means the system relative axis is completed the 2 nd (or the 3 rd ,
4 th ) reference return procedure and stop at the 2 nd (or 3 rd , 4 th ) reference point.
S Bit 028
Description:
Warning
When system warning occurs, this signal will notify PLC. After cause is eliminated, system
warning is off automatically and this signal is OFF.
S Bit 029
Description:
M Code Read
When executing to the M code, this signal is “ON” in order to provide LADDER to do M code
executing until FIN signal replies back. Please refer to the description of M code end signal (C
BIT 038).
100 LNC Technology Co., Ltd.