LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
WARNING ID
Warning Message
OP 6001 X AXIS OVER MLC TRAVEL LIMIT (+)
OP 6002 X AXIS OVER MLC TRAVEL LIMIT (-)
OP 6003 Y AXIS OVER MLC TRAVEL LIMIT (+)
OP 6004 Y AXIS OVER MLC TRAVEL LIMIT (-)
OP 6005 Z AXIS OVER MLC TRAVEL LIMIT (+)
OP 6006 Z AXIS OVER MLC TRAVEL LIMIT (-)
OP 6007 4TH AXIS OVER MLC TRAVEL LIMIT (+)
OP 6008 4TH AXIS OVER MLC TRAVEL LIMIT (-)
Warning/Alarm Cancel:
After the above system warning message is enabled, need to wait until the servo moves toward
the opposite direction. And also, the corresponding C BIT changes from ON to OFF, the
warning message will be removed automatically.
In JOG/RAPID or MPG mode, if the system warning message (OP 6001 〜 OP 6008) of MLC
travel limit occurs, it is okay not to remove the warning message. Just moving directly to the
reverse direction away from where the warning message occurs. After getting away from the
software limitation range, the warning message will be removed.
Under mode of MEM, MDI or HOME, if the system warning message (OP 6001 〜 OP 6008) of
MLC travel limit occurs, OP will send out the warning message. In this case, users must press
“RESET” to reset the system.
ALARM ID
OP 1020
Warning Message
OVER MLC TRAVEL LIMIT
C Bit 059
C Bit 060
C Bit 061
C Bit 062
Description:
X Axis Interlock
Y Axis Interlock
Z Axis Interlock
4th Axis Interlock
When the corresponding axis is ON, the axis will NOT move. But, the coordinate value will be
renewed.
C Bit 066
C Bit 067
C Bit 068
C Bit 069
Description:
X Axis: Select Axis Direction Signal of Handle INT
Y Axis: Select Axis Direction Signal of Handle INT
Z Axis: Select Axis Direction Signal of Handle INT
4th Axis: Select Axis Direction Signal of Handle INT
Assumed NC is under MEM mode. User can use Manual Handle Interrupt function to
LNC Technology Co., Ltd. 89