LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
increase/decrease tool shifting amount in order to modify path. However, before using this
function, user must set Handle Interrupt axis selection signal and MPG ratio (R REGISTER
014). Then, user can use MPG to modify tool position. However, absolute coordinate will NOT
be modified by Handle Interrupt, there will be a OFFSET amount of the initial program path and
afterward tool path. This OFFSET amount will be cleared only by using manual reference point
return.
C Bit 075
C Bit 076
C Bit 077
C Bit 078
Description:
X Axis Servo Alarm
Y Axis Servo Alarm
Z Axis Servo Alarm
4th Axis Servo Alarm
This signal will notify system if motor driver of any axis has any extraordinary phenomenon.
90 LNC Technology Co., Ltd.