LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
52 NUMBER OF 1ST SPINDLE.2A GEAR
667 NUMBER OF 2ND SPINDLE.2A GEAR
675 NUMBER OF 3RD SPINDLE.2A GEAR
Range: 1 ~ 32767
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
this parameter is to set the numerator of the 2 nd spindle gear ratio. When the
spindle is at the 2nd gear, C BIT 097 is ON.
If this ratio is greater than 1, it is a deceleration relationship between the motor
and the spindle. If this ratio is smaller than 1, it is an acceleration relationship
between the motor and the spindle.
57 1ST SPINDLE FEEDBACK MULTIPLY
890 2ND SPINDLE FEEDBACK MULTIPLY
894 3RD SPINDLE FEEDBACK MULTIPLY
Range: 1 ~ 4
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
this parameter is to set ENCODER feedback multiple factor of spindle, this
parameter works only when the ENCODER feedback multiple factor of spindle
is AB PHASE (setting value of Parameter 0195 is 0); if the ENCODER feedback
multiple factor of spindle is CW/CCW or PULSE/DIRECTION (setting value of
Parameter 0195 is either 1 or 2), then the feedback multiple factor of spindle is
1 permanently.
Assumed the spindle control method is PULSE COMMAND (under spindle
orientation and rigid rapping modes), the multiple product of this parameter
setting value and parameter #1116 setting value (total pulse per rotation of
spindle motor ENCODER) is the PLUSE command value that is sent by NC in
order to make spindle motor to rotates one time. If the spindle control method is
V COMMAND, then the multiple product of this parameter setting value and the
parameter 1116 setting value will only be used to calculate the actual rotational
speed of spindle.
889 2ND SPINDLE ENCODER PPR
893 3RD SPINDLE ENCODER PPR
Range: 1 ~ 32767
Active: Active After Reboot
Level: Machinery Builder
Default 1024
value:
176 LNC Technology Co., Ltd.