LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1059 1ST SPD RIGTAP ACC/DEC TIME
Range: 1 ~ 32767
Active: Active After RESET
Level: Machinery Builder
Default 500
value:
Unit: ms
Description:setting under the rigid tapping mode, spindle’s acc/deceleration time. Since
under the rigid tapping mode, the movement amount of Z-axis is calculated by
the spindle movement so this parameter also set the acc/deceleration time for
Z-axis.
1060 1ST SPD RIGTAP EXTRACTION RATE
Range: 1 ~ 400
Active: Active After RESET
Level: Machinery Builder
Default 100
value:
Unit: %
Description during rigid tapping returning, the needed cutting power is small, so can use this
:
parameter to set the increasing return speed.
Example, if setting value is 200, this means during returning procedure, the
spindle turns by two times of the original commanding rotational speed, Z-axis
moves by two times of the original commanding the feedrate. But, the faster the
rotational speed, the larger the following error of Z-axis. So must be careful in
order to prevent crash situation. Also, must be careful of the limitation of the
highest turning speed of the spindle and the highest cutting speed of the Z-axis.
LNC Technology Co., Ltd. 191