LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
rebooting default value 99999.999 um. If this parameter setting value is larger
than parameter # 1006 (+ive X-axis
software travel limit), it will enable the alarm system (MOT 4005, 1 st software
traveling limit setting error). The -ive X axis 1 st and 2 nd software traveling limit is
able to execute exchanging through C BIT 141. Please refer to the description
of C BIT. Under the condition that the -ive X axis 1 st software traveling limit is
enabled, when X axis will excess the restricted range, it will enable the alarm
system (MOT 9002 X axis over the –ive software travel limit) or (MOT 4058 over
the software travel limit). Please refer to the description of this warning
message.
1034 2ND X+ SOFT LIMIT
1036 2ND Y+ SOFT LIMIT
1038 2ND Z+ SOFT LIMIT
1040 2ND 4+ SOFT LIMIT
Range: -99999999 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default 99999999
value:
Unit: um
Description
:
this parameter is to set the limitation value of the +ive X axis software travel
limit. It works only after X axis is completed zero return procedure, or using the
rebooting default value 99999.999 um. If this parameter setting value is smaller
than parameter # 1035 (-ive X axis
software travel limit), it will enable the alarm system (MOT 4023, 2 nd software
traveling limit setting error). The +ive X axis 1 st and 2 nd software traveling limit is
able to execute exchanging through C BIT 140. Please refer to the description
of C BIT. Under the condition that the +ive X axis 2 nd software traveling limit is
enabled, when X axis will excess the restricted range, it will enable the alarm
system (MOT 9001 X axis over the +ive software travel limit) or (MOT 4058 over
the software travel limit). Please refer to the description of this warning
message.
252 LNC Technology Co., Ltd.