LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
S Bit 134
Description:
Max Working Piece Arrival
When the number of working piece is greater than or equal to that of the maximum
setting-working piece, S134 will be sent out to inform MLC. If setting the maximum working
piece to zero, then this signal will not be sent out. MLC will use C134 to inform NC to clear
working piece.
Application Description:
Enter into user parameter to do function selection and set parameter No. 12 as 1. When the
working piece number reaches the setting working piece number, it will enter into the Feed Hole
condition and send out warning message (Wrokpiece is full).
At this time, user can do any needed motion. If there is no need to do any other motion, please
press “Cycle Start” key directly. Then the working piece number will be cleared to zero
automatically. Furthermore, it will start working automatically and counting working piece
number from zero. If no need this function at all, then set parameter No.12 as 0. Circulating
work of working piece will not be affected.
01 Program Editing 0 11 Power Off Delay Time 5
02 Home Point Search Priority 1 12 Work Piece Alarm 1
03 Return Home Axis Priority 1 13
04 Rapidly Moving 50% 0 14
05 Total Number of Turret 0 15
06 Safety Door 0 16
07 Enforce Track Lubrication 0 17
08 Lubricate ON Time 5 18
09 Lubricate OFF Time 30 19
10 Auto Power Off Function 1 20
110 LNC Technology Co., Ltd.