LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
S Bit 030
Description:
Distribution EndAlarm
In MEM or MDI mode, when the moving command interpolation is completed, this signal will be
sent out. So when M code and the moving G code are on the same BLOCK, please use this
signal to control and to execute M code after moving G code. If do not use this signal, M code
will be executed simultaneously with G code interpolation.
S Bit 031
Description:
Alarm
When the system alarm is on, this signal is ON.
S Bit 032
Description:
Reset
When the system receives the RESET command, this signal is ON. Remain one time scanning
time in order for LADDER to reset.
S Bit 033
Description:
NC Ready
Assumed the controller’s power is on. After normally executing program, this signal will be ON.
S Bit 035
S Bit 036
S Bit 037
S Bit 038
Description:
MPG x1000 Ratio Speeding
MPG x1 Ratio Speeding
MPG x10 Ratio Speeding
MPG x100 Ratio Speeding
These four signals are used to indicate the current using MPG ratio.
MPG Ratio S035 S036 S037 S038
x1 0 1 0 0
x10 0 0 1 0
x100 0 0 0 1
x1000 1 0 0 0
S Bit 039
Description:
Program Restart
When system enters the Program Restart process, the state signal of Program Restart will be
enable(S39=ON), and will be disable when the system is completed or leave the operational
status of Program Restart.
S Bit 040
Description:
Single Block
Conditional signal that is relative to single block (SBK).
S Bit 041
Description:
Optional Block Skip
Conditional signal that is relative to Optional Block Skip(BDT).
LNC Technology Co., Ltd. 101