LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
5.3 Machine Parameter
62 UNITS OF #104~#107 PARAMS
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
this parameter is used to set unit system for the setting value of parameters
0104 ~ 0107.
68 DENOMINATOR OF GEAR RATIO.X
69 DENOMINATOR OF GEAR RATIO.Y
70 DENOMINATOR OF GEAR RATIO.Z
72 DENOMINATOR GEAR RATIO.4
Range: 1 ~ 32767
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
This parameter is to set the denominator for X axis motor gearratio. If gear ratio
of X axis is bigger than 1, there is a deceleration relationship between X axis
motor and ball screw. If gear ratio of X axis is smaller than 1, there is an
acceleration relationship between X axis motor and ball screw.
100 NUMERATOR OF GEAR RATION.X
101 NUMERATOR OF GEAR RATION.Y
102 NUMERATOR OF GEAR RATION.Z
103 NUMERATOR OF GEAR RATION.4
272 NUMERATOR OF GEAR RATION.5
Range: 1 ~ 32767
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
This parameter is to set the numerator for each axis ball screw.
If the gear ratio of each axis is bigger than 1, there is a deceleration relationship
between each axis motor and ball screw. If this ratio is smaller than 1, there is
an acceleration relationship of each axis motor and ball screw.
LNC Technology Co., Ltd. 171