LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Appendix B: Servo Connection Example
B4 TOSHIBA converter
Starting & AUTO – TUNING Steps:
Please Follow the below Parameter Adjustment Steps after Power ON:
1.Para. vL:Base frequency #1(25 ~ 400 )
(Normal setting value is 60).
2.Para. F306:Voltage of base frequency(output voltage adjustment)
(Normal setting value is 0 ~ 600V).
3.Para.F411:Nμmber of poles of motor(2、4、6、8、10、12、14、16、18)
(Normal setting value is 4).
4.Para.F412:Rated capacity of motor( 0.1 ~ 280kw)
Setting value is according to Output ratio on motor brand.
5.Para.F413:Motor type( 0 ~ 4)
(Normal setting value is 4).
6. Executing auto-tuning.
Para.F400:To set auto-tuning selection as 2(auto-tuning enabled)
7. When auto-tunning is finish, inverter will auto-save the new parameter after testing.
Para.F401 ~ F410 auto-setting value.
8.Finish Steps 1~7 and doing CW/CCW testing.
Para.Fr(Forward/Reverse selection) 0:Forward 1:Reverse
(This parameter is effective on OP operation method. )
9. To set Para.cnod(operation command mode selection)to 1.
324 LNC Technology Co., Ltd.