LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Hardware Maintenance
3.4.7.2 Transit board slots definition
Connecter Type Description Wiring instruction
P1 ~ P4 D_SUB 25PIN(F) 4 axisPULSE axis To servo
P5 D_SUB 25PIN(F) 1620V2.0 PULSE axis5 To servo
P6 D_SUB 25PIN(F) 1620V2.0 MPG To MPG
P7 D_SUB 25PIN(F) 1620V2.0 Vcmd axis1 To servo
P8 D_SUB 15PIN(F) Control signal of ON/OFF To Operation panel
P9 D_SUB 9PIN(F) 1620 V2.0 ENC 6th transit To 1620 V2.0 P4
J1 4PIN 5.08mm plug-in DC(24V、5V) supply input To POWER
J2 ~ J5 4PIN 5.08mm plug-in HOME(*) and OT contact To SENSOR
J6 4PIN 5.08mm plug-in OT contact To SENSOR
J7 4PIN 5.08mm plug-in ALARM1~4 To RELAY board IN
J13 3PIN 5.08mm plug-in ALARM5 ~6、ESP examination To RELAY board IN
J8 2PIN 5.08mm plug-in All servo RESET signal To RELAY board
contact
J9 2PIN 5.08mm plug-in All servo READY signal To RELAY board
contact
J10 2PIN 5.08mm plug-in PC uses AC POWER out To PC AC POWER
J11 2PIN 5.08mm plug-in Servo uses POWER out To servo POWER
J12 2PIN 5.08mm plug-in System AC POWER in To AC supply
U1 SCSI- Ⅱ 68PIN Motion control signal contact To 68PIN connecter
motion control card
(Note)The ONBOARD HOME only provides 4 spots, toing annex the other
HOME spot to need through SIO board.
60 LNC Technology Co., Ltd.