LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
78 ENABLE C AXIS TANGENT FOLLOW
292 ENABLE C AXIS PATH FOLLOWING
Range: 0 ~ 1
Active: Active After Reboot
Level: User
Default 0
value:
Unit: Nul
Description
:
When this function is enabled, C axis moving angle will move by following XY
cutting line direction.
83 ENABLE G00 UNDER DRY RUN
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 1
value:
Unit: Nul
Description
: Under Dry Run, Motion of RAPID TRAVERSE Command
Para #0083
0 1
Para #0041 Para #0041
0 1 0 1
RAPID mode (1)
In MEM and MDI modes, G00
command and/or motion with
G00 command
(2) (3) (1) (4)
G00 and G53 commands of PMC
axis function
C23 OFF:
(1)
C23 ON:
(1)
C23 OFF:
(3)
C23 ON:
(4)
(1) (4)
(1) Each axis moves according to its G00 speed.
(2) Each axis moves according to its JOG speed
(3) Each axis moving speed will NOT excess its setting JOG speed.
(4) Each axis moving speed will NOT excess its setting G00 speed.
89 M CODE ID OF PART COUNTER
Range: 1 ~ 99
Active: Active After RESET
LNC Technology Co., Ltd. 231