LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
5.5 MPG Parameter
15 AXIS.HANDLE FOR MPG DRY RUN
Range: 1 ~ 19
Active: Active After Reboot
Level: Machinery Builder
Default 6
value:
Unit: Nul
Description
:
this is used to set connection port number of the handwheel under MPG dry fun
mode (works only in MEM or MDI modes).
18 MPG MULTIPLIER MODE
Range: 0 ~ 1
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description This parameter is to set the cutting axis acceleration/deceleration time under
:
Lathe-Tapping cutting command. The smaller the parameter value, the faster
the cutting axis reaches the designated moving speed. However, it may cause
vibration of cutting axis.
In 486IPC(IPO is 5ms), max. value of this parameter is 1000.
In 586IPC(IPO is 3ms), max. value of this parameter is 1000.
When the setting value is less than IPO interval of the above restricted value,
System Alarm【MOT 4056: Lathe-Tapping Acc/Dec Time (Para. # 0018) Setting
Error】will occur.
LNC Technology Co., Ltd. 201