LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
40 MIN.F OVERRIDE VALUE FOR G00
Range: 0 ~ 25
Active: Active After RESET
Level: User
Default 10
value:
Unit: %
Description This parameter is to set the correspondent % value of RAPID TRAVERSE when
:
the feedrate OVERRIDE knob is set to 0%. For example, is this parameter is set
as 10, when the OVERRIDE knob is set to 0%, actually it corresponds to 10%.
53 FEEDBACK MUL FACTOR.4TH
54 FEEDBACK MUL FACTOR.X
55 FEEDBACK MUL FACTOR.Y
56 FEEDBACK MUL FACTOR.Z
Range: 1 ~ 4
Active: Active After Reboot
Level: Machinery Builder
Default 4
value:
Unit: Nul
Description
:
This parameter is to set the feedback multiply factor of the X-axis ENCODER
and is effect only when X-axis ENCODER feedback signal is set as AB PHASE
(i.e. Parameter # 0191 set as 0). If the X-axis ENCODER feedback signal is set
as CW/CCW or PULSE/DIRECTION (i.e. Parameter # 0191 set as 1 or 2), the
feedback multiply factor remains 1 all the time.
In PULSE COMMAND mode, the value is the product of this parameter set
value and the set value of Parameter #0058 (i.e. ppr) is the total pulse per
rotation that NC intents to let the X-axis motor to achieve.
156 LNC Technology Co., Ltd.