LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Appendix B: Servo Connection Example
When AUTO – TUNING is finish and basic motor parameter data is key-in, executing
parameter adjustment immediately.
There are 24 basic parameters. F100 ~ F800 are extension parameters.
Bais Parameter Setting:
Parameter Function Setting Range
AU1
Automatic
acceleration /
deceleration
0:disabled(manual setting)
1:enabled(automatic setting)
Setting
Value
This parameter controls ACC/DECELERATION Speed
AU1=1: Auto acc/deceleration speed adjustment. But, user must set a constant value
for the acceleration/deceleration parameter. This parameter will do 1/8 ~ 8 time
auto-adjusting setting according to the acc/deceleration value.
AU1=0:This function is disable which means that acc/deceleration is controlled by this
parameter value.
Figure 1 and Figure 2 are automatically time changing figure when overloading size
changes. The below two figures show that this parameter can control the actual
rotational speed in order to prevent any unusual sound.
0
Acc/Deceleration Time when Small
Overloading
Acc/Deceleration Time when Large
Overloading
Time
Time
Accleration
Time
Deceleration
Time
Acceleration
Time
Deceleration
Time
Figure 1 Figure 2
LNC Technology Co., Ltd. 325