LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
2
1 T 2
Calculating formula is : ∆ R = ( + ) V . K
2 p
is position
2K
R 24R
loop incremental. T is acceleration and deceleration time integer
number. R is arch radius and V is the assigned feedrate. This
formula is used only when the corresponding speed of speed loop
is 3 ~ 10 times faster than position loop.
Please also refer to description of Parameter 0188 and 0809 for
detailed description.
p
200 FEEDRAT SHOW 0)CMD 1)ACTUAL
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 0
value:
Unit: Nul
Description
:
0:HMI panel displays feedrate commanding value
1:system will calculate the actual feedrate according to each axis motor
ENCODER (or linear scale) and then will display it on HMI panel.
202 ENG/CHI/SIM LANG SETTING
Range: 0 ~ 2
Active: Active After Reboot
Level: User
Default 1
value:
Unit: Nul
Description
:
0:English
1:Traditional Chinese
2:Simplify Chinese
205 REL/ABS COMP VALUE
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 0
value:
Unit: Nul
Description
:
Using this parameter to set the entering tool compensation value at OFFSET
page, either absolute value or relative value.
LNC Technology Co., Ltd. 243