LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
249 RAMDISK ERR MSG 0)OFF 1)ON
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
0: 當 RAMDISK 發 生 異 常 時 , 不 顯 示 警 告 訊 息 。
1: 當 RAMDISK 發 生 異 常 時 , 顯 示 警 告 訊 息 。
350 JOG FRATE REF TO MDI F COMMAND
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 0
value:
Unit: Nul
Description 0:In JOG mode, the speed of each axis is always defined by parameters.
:
1:In JOG mode, the speed of each axis is preset by parameters. If executing F
code in MDI mode, F code replaces JOG speed to set the speed of each axis
until RESET is pressed. However, in JOG mode, the highest speed of each axis
is still set by parameters.
351 FEEDRATE OVERRIDE UNIT
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
0:Cutting override feed rate = R016 register value* 10%;
1:Cutting override feed rate = R016 register value* 1%。
246 LNC Technology Co., Ltd.