LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
R Bit 024
R Bit 025
R Bit 026
R Bit 027
R Bit 028
R Bit 029
R Bit 030
R Bit 031
Description:
PMC Function of X-Axis Command Amount, Unit=mm
PMC Function of X-Axis Command Amount, Unit=um
PMC Function of Y-Axis Command Amount, Unit=mm
PMC Function of Y-Axis Command Amount, Unit=um
PMC Function of Z-Axis Command Amount, Unit=mm
PMC Function of Z-Axis Command Amount, Unit=um
PMC Function of 4th-Axis Command Amount, Unit=mm
PMC Function of 4th-Axis Command Amount, Unit=um
When setting PMC axis to execute moving command, the designated moving distance must be
divided into two parts, which one is mm part and the other is um part, and be set into each
register separately.
R Bit 040
R Bit 041
R Bit 042
R Bit 043
R Bit 044
R Bit 045
Description:
MLC Alarm Message
MLC Alarm Message
MLC Alarm Message
MLC Alarm Message
MLC Alarm Message
MLC Alarm Message
The driver signal of alarm message provides MLC LADDER to send out alarm. There are six
registers(word), and the sum of 96 messages can provide definitions and drivers. For
example, LADDER must put a constant 5 into R40 with moving command(MOV). The strings
of message must define at corresponding position in ENC_MLC.ERR simultaneously. In the
same way, if setting R40 for zero, MLC ALARM will be cleaned.
118 LNC Technology Co., Ltd.