LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
SYSTEM ALARM and WARNING
MOT 4019:OVER TRAVEL
(1)Machine over travel problem.
(2)Solving the problem according to alarm message (OP 005~0012).
MOT
4020:NO RESIDUE DATA
MOT
4021:STOP POSITION ERROR
MOT 4022:FIRST SOFT LIMIT ERROR
(1)Over 1 st soft limit. (Please refer to G10 in program manual.)
(2)Please checking setting values of parameters 1006 ~ 1013.
(3)Clicking RESET to continue operating from the reverse direction.
MOT 4023:SET SECOND SOFT LIMIT ERROR
(1)Maximum parameter value of the 2 nd soft limit is smaller than the smallest value.
(2)Checking parameters 1034~1041.
(3)Reset parameter and then reboot.
MOT 4024:SECOND SOFT LIMIT ERROR
(1)Over 2 nd soft limit.
(2)Checking parameters 1034~1041.
(3)Click RESET to continue operating.
MOT 4025:G10 P RANGE ERROR
(1)P value is over range.
(2)Please checking the part program.
MOT 4026:ENCODER A,B PHASE ERROR
(1)ENCODER disconnect or 5V power problem
(2)Checking whether or not the ENCODER or power port is connected.
MOT 4027:HOME DOG TOO SHORT
(1)Check whether or not HOME DOG is too short or the speed is too fast.
(2)Extend DOG or slow down the zero return speed.
MOT
4028:SET PARAM 39 ERROR
LNC Technology Co., Ltd. 271