LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
Default
value:
Unit:
Description
:
1
Nul
the valid range of this parameter setting value is as following:
1. Reboot coordinate display value;
2. After zero return procedure is completed, coordinate display value;
3. G54 ~ G59 commands(work coordinate system selection);
4. G92 command(coordinate value setting).
71 INNER/OUTTER CHECK OF G22
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 0
value:
Unit: Nul
Description 0:the embedded travel checking function that is set by G22 is the external
:
prohibit area. When there is command that will move the tool to outside of the
setting range, the system alarm will be enabled.
1:the embedded travel checking function that is set by G22 is the external
prohibit area. When there is command that will move the tool to outside of the
setting range, the system alarm will be enabled.
About system alarm, please refer to the description of MOT 4058、9009 ~
9014.
73 ENABLE G31 ACCELERATION
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
0:after G31 SKIP SIGNAL enters, immediately stop without decelerating;
1 : after G31 SKIP SIGNAL enters, use parameter 0041 to set the
acc/decelerating time in order to proceed stop in decelerating speed.
74 ENABLE MACRO TRACE UNDER SBK
Range: 0 ~ 1
Active: Active After RESET
Level: User
Default 0
value:
Unit: Nul
Description
:
0:Macro command (not NC command) Not execute single block;
1:Macro command (not NC command) execute single block.
230 LNC Technology Co., Ltd.