LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Appendix B: Servo Connection Example
When torque produced in low speed range is not large enough, it can be boosted up by
increasing the torque boost rate with this parameter
This parameter can be used with:
PE=0(V/f constant)
PE=1(square reduction)
PE=6(V/f 5-point setting)
(Note)This value must not be too high. Everytime’s incremental can not be over2% of
setting value, or over current will occur.
Base-frequency F306
ub
7
Output frequency(Hz)
330 LNC Technology Co., Ltd.