LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Hardware Maintenance
3.3.7 Hardware Description
The IPC module and the motion control card module constitute ELC1000MA, and ports
and light definition descript as below:
ELC1000MA IPC module
Mark Description Note
COM1、COM2、FLOPPY、
IDE、USB、ETHERNET、
VGA、PS2
Normal PC interface Some USB devices need
additional drivers
CF CARD CF card interface Including system software
DC POWER 12V GND 5V ELC1000MA power input
5V(6A or higher) 12V(2A)
Please check that input value
is equal to the mark, and try to
shorten the cable of the power
supply to prevent voltage
down. (4.8V or lower might
make the controller abnormal)
PCC1840 motion control card module
Mark Description Note
RIO1、RIO2
Serial IO control port. It
can control 2 IO sets
Please refer to the instruction
of the IO card
LIO PCC1840 ON_BOARD Input 24V, output using open
IN/OUT
collector
MOTION Motion control signal
output
E5V light(green) Pulse output signal power Pulse signal can’t be sent
when the light off
20 LNC Technology Co., Ltd.