LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
SYSTEM ALARM and WARNING
MOT 4006:X AXIS SERVO LAG OVERFLOW
(1)X Axis servo lag over parameter 0002 setting value.
(2)Check whether the setting speed is too fast or the parameter 0002 setting value
is too small.
(3)Clicking RESET to continue operating.
(4)If reset parameter, must reboot.
MOT 4007:Y AXIS SERVO LAG OVERFLOW
(1)Y Axis servo lag over parameter 0003 setting value.
(2)Check whether the setting speed is too fast or the parameter 0003 setting value
is too small.
(3)Clicking RESET to continue operating.
(4)If reset parameter, must reboot.
MOT 4008:Z AXIS SERVO LAG OVERFLOW
(1)Z Axis servo lag over parameter 0004 setting value.
(2)Check whether the setting speed is too fast or the parameter 0004 setting value
is too small.
(3)Clicking RESET to continue operating.
(4)If reset parameter, must reboot.
MOT 4009:4TH AXIS SERVO LAG OVERFLOW
(1)4th Axis servo lag over parameter 0005 setting value.
(2)Check whether the setting speed is too fast or the parameter 0005 setting value
is too small.
(3)Clicking RESET to continue operating.
(4)If reset parameter, must reboot.
MOT 4010:SPINDLE FEED FUNCTION ERROR
(1)Checking spindle G25/G26 rotation speed.
(2)Checking whether or not the setting values of parameter 57, 61 and 92 are
correct.
(3)Checking whether or not the spindle is working normally.
(4)Clicking RESET to continue operating.
(5)If change the parameter, need to reboot for the new setting parameter to be
effective.
LNC Technology Co., Ltd. 269