LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
189 1ST SPD INITIAL SPEED
875 2ND SPD INITIAL SPEED
Range: 0 ~ 99999
Active: Active After Reboot
Level: User
Default 0
value:
Unit: RPM
Description Spindle default rotational speed when system start
:
190 1ST SPD POSITION COMMAND TYPE
Range: 0 ~ 6
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description 0:A/B PHASE
:
1:CW/CCW
2:PULSE/DIRECTION
System is use PULSE COMMAND to drive Spindle when it s doing Spindle
orientation and is under rigid tapping mode. This parameter is to set this
commanding PULSE format. Please set the commanding PLUSE format
according to Spindle inventor.
186 LNC Technology Co., Ltd.