LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
S Bit 074
Description:
Optional Stop
ON/OFF control on the communication style software Panel will communicate with LADDER
through this signal. For Optional Stop key on the software Panel, ON/OFF control will
communicate with LADDER through this signal. The timing procedure is as following:
S074
C044
S044
S Bit 080
S Bit 081
S Bit 082
S Bit 083
Description:
M00 Read
M01 Read
M02 Read
M30 Read
M00:after interpreting as M00, this signal is ON(remain one time scanning time)
M01:after interpreting as M01, this signal is ON(remain one time scanning time)
M02:after interpreting as M02, this signal is ON(remain one time scanning time)
M30:after interpreting as M03, this signal is ON(remain one time scanning time)
S Bit 086
Description:
Orientation Finish
When spindle orientation is completed, this signal is ON. When PLC cancels the spindle
orientation command (C85), this signal will become OFF.
LNC Technology Co., Ltd. 107