LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
210 HOME POINT FOR LINEAR SCALE
Range: 0 ~ 63
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:This parameter is only applicable to Heidenhain’s linear scale with multiple
reference marks. Please use BIT to set the relative position of each axis’s
machine zero point and the linear scale’s zero point (Only valid when the
relevant BIT value to parameter No. 0209 is set to 1).
0:Machine zero point is at the positive side of the linear scale’s reference mark;
1:Machine zero point is at the negative side of the linear scale’s reference
mark.
293 ZRN BY DOG OR INDEX
Range: 0 ~ 63
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:BIT0:0 means X axis uses DOG for machine reference point reference and 1
means X uses motor INDEX signal for reference.
BIT1:0 means Y axis uses DOG for machine reference point reference and 1
means Y uses motor INDEX signal for reference.
BIT2:0 means Z axis uses DOG for machine reference point reference and 1
means Z uses motor INDEX signal for reference.
220 LNC Technology Co., Ltd.