LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
5 Parameter
Parameters seprated into 7 types: servo parameter, machine parameter, spindle parameter,
MPG parameter, compensation parameter, original parameter, and operation parameter.
Note:
1. Four effective times due to different parameter setting values.
a:Effective immediately
b:Effective after RESET(R)
c:Effective after rebooting(⊙)
d:Effective after re-power on(ㄣ)
2. Two types of authorization status according to each parameter’s functions. However,
under 【End-User】status, some parameter will NOT occur:
a:End-user
b:Machine maker
3. Some parameters use Bit method to set whether or not to enable a certain function.
Usually, Bit0 corresponds X axis, Bit1 corresponds Y axis, Bit2 corresponds Z axis.
The setting method is as below:
Bit0:1 means 1 in 1, 2, 4, 8, 16, 32 and so on
Bit1:1 means 2 in 1, 2, 4, 8, 16, 32 and so on;
Bit2:1 means 4 in 1, 2, 4, 8, 16, 32 and so on;
Bit3:1 means 8 in 1, 2, 4, 8, 16, 32 and so on;
Bit4:1 means 12 in 1, 2, 4, 8, 16, 32 and so on;
So, if want to set a certain Bit to 1, only need to adding up the corresponding value
into the parameter. For example, if want to set both Bit1 and Bit3 to 1, the setting
value of this parameter is 10(2 + 8).
LNC Technology Co., Ltd. 127