LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
value:
Unit: 1/S
Description:When the spindle’s command format in control mode is V command (parameter
No. 0190 = 3), this parameter sets the spindle’s proportional gain during rigid
tapping.
248 1ST SPD ORIENT OFFSET UNIT
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: NUL
Description:0: Unit of OFFSET amount between Spindle Orientation point and center point
(Parameter #1056 and System Data #10) is pulse.
1: Unit of OFFSET amount between Spindle Orientation point and center point
(Parameter #1056 and System Data #10) is 0.001 degree.
354 1ST SPD OVERRIDE UNIT
355 2ND SPD OVERRIDE UNIT
356 3RD SPD OVERRIDE UNIT
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:0:The 1 st (2 nd & 3 rd ) spindle’s rotation override speed = R015 (R019、R020)
register value * 10%;
1:The 1 st (2 nd & 3 rd ) spindle’s rotation override speed = R015 (R019、R020 )
register value* 1%。
393 1ST SPINDEL GEARING METHOD
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:Choose either “automatic” or “manual” gear change method to be the spindle’s
gear change method
0:Automatic gear change
1:Manual gear change
188 LNC Technology Co., Ltd.