LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
Home point when executing return Home process.
BIT 3: 0 means when 4th axis is in Home point mode, the system must
research Home point when executing return Home process.
1 means when 4th axis is in Home point mode, the system uses NC record’s
Home point when executing return Home process.
208 REFERENCE MARKS OF LINEAR SCALE
Range: 0 ~ 63
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:For a servo axis that uses a linear scale with multiple reference marks, zero
point return can be done manually by measuring the signal intervals between
any 2 or 3 reference positions. (Please use parameter No. 0209 & 0210 to set
other relevant actions).
BIT0:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of X axis; 0 means not used.
BIT1:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of Y axis; 0 means not used.
BIT2:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of Z axis; 0 means not used.
BIT3:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of the 4 th axis; 0 means not used.
(Below is for 6-axis version)
BIT4:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of the 5 th axis; 0 means not used.
BIT5:1 Heidenhain’s linear scale with multiple reference marks is used for
position feedback of the 6 th axis; 0 means not used.
209 HOME RETURN FOR LINEAR SCALE
Range: 0 ~ 63
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:This parameter is only applicable to Heidenhain’s linear scale with multiple
reference marks. When executing zero return manually, please use BIT defined
as follows to set the numbers of reference mark signals that need to be checked
for each axis.
0:In manual mode, 3 reference marks must be checked to complete the zero
return.
1:In manual mode, only 2 reference marks have to be checked to complete the
zero return. If this option is adopted, parameter No. 0210 must be set
additionally.
LNC Technology Co., Ltd. 219