LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
156 CONTROL CMD FORMAT OF X
157 CONTROL CMD FORMAT OF Y
158 CONTROL CMD FORMAT OF Z
159 CONTROL CMD FORMAT OF 4
Range: 0 ~ 3
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
0:A/B PHASE;
1:CW/CCW;
2:PULSE/DIRECTION。
Besides setting command type from the NC side, you have to select the same
command type in MOTOR DRIVER side. If set as 1 or 2, you are also required
to set the pulse wide. Please refer to Parameter # 1072. (When set as A/B
PHASE, the motion board will automatically adjust to 50% DURATION).
172 G00 ACC. TYPE 0)LINE 1)S CURVE
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description
:
0:Linear acceleration/deceleration
1:S-curve acceleration/deceleration
Servo Axis
Para. #1000 ~ Para. 1003 #1000 Setting ~ 1003 Setting
Servo Axis
Para.# 0010 ~ 0013 Setting
Time
Linear Acc/Dec
Time
Para.# 0010 ~ 0013 Setting
S Curve Acc/Dec
LNC Technology Co., Ltd. 161