LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
5.4 Spindle Parameter
16 ACC/DEC TIME OF 1ST SPINDLE
885 ACC/DEC TIME OF 2ND SPINDLE
888 ACC/DEC TIME OF 3RD SPINDLE
Range: 0 ~ 32767
Active: Active After RESET
Level: Machinery Builder
Default 1000
value:
Unit: MS/KRPM
Description
:
This parameter sets the corresponding output voltage of Spindle rotation and
acc/deceleration speed of Pulse command. When Spindle rotational signal uses
voltage output, user must sets OFFSET of voltage output signal and the
corresponding RPM of 10 V.
21 1ST SPD ORIENTATION RPM
Range: 1 ~ 20000
Active: Active After RESET
Level: Machinery Builder
Default 100
value:
Unit: RPM
Description this parameter is used to set rotational speed of spindle orientation . When the
:
spindle orientation is doing machine adjustment, the spindle rotational speed is
decided by this parameter. In order to prevent any error by different rotational
speed, please do NOT modify this parameter setting value after machine
adjustment of spindle orientation is completed.
LNC Technology Co., Ltd. 173