LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1065 1ST SPD RIGTAP ACCELERATED COMP
Range: 0 ~ 100000
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description after rigid tapping is completed, please set the commanding
:
compensation value as the display value of data system #022 at
(Diagnostic) DGNOS page.
1066 1ST SPD RIGTAP VELOCITY FILTER
Range: 0 ~ 20
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description the bigger the value, the less vibration will occur. , but the
:
bigger the rigid tapping following error will be. When enter 0, this means
there is no filting effect. When enter the maximum value (i.e., 20), this
means there is a completely filting effect, which means the signal is filited
completely. Please adjust this parameter setting value during the rigid
tapping machine adjustment.
LNC Technology Co., Ltd. 193