LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
116 MOVING DIR OF SERVO AXES(BIT)
Range: 0 ~ 63
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description BIT0:when set as 1, the X-axis should move in reverse direction against
:
previous movement. When set as 0, there is no reverse movement.
BIT1:when set as 1, the Y-axis should move in reverse direction against
previous movement. When set as 0, there is no reverse movement.
BIT2:when set as 1, the Z-axis should move in reverse direction against
previous movement. When set as 0, there is no reverse movement.
BIT3:when set as 1, the 4 TH -axis should move in reverse direction against
previous movement. When set as 0, there is no reverse movement.
BIT4:when set as 1, the spindle-axis should rotate in reverse direction against
previous. When set as 0, there is no reverse rotation. This only effects
only when the spindle is under PULSE COMMAND, such as spindle
orientation and rigid tapping.
Description: Take the X-axis for example, under JOG mode, if you pressed the
+x button on the OP panel, the machine X-axis moves in negative direction, it
means motor’s positive rotation is in reverse to +X axis direction. Please set
BIT0 as 1. if you pressed the +x button on the OP panel, the machine X-axis
moves in positive direction as well, please set BIT0 as 0. Such is the same with
all the rest axis.
160 LNC Technology Co., Ltd.