LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
195 ENCODER TYPE OF 1ST SPINDLE
891 ENCODER TYPE OF 2ND SPINDLE
895 ENCODER TYPE OF 3RD SPINDLE
Range: 0 ~ 3
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
this parameter is to set the spindle Encoder’s output signal type.
0:A/B PHASE
1:CW/CCW
2:PULSE/DIRECTION
3:none
226 MOVING DIR. OF SPINDLES(BIT)
Range: 0 ~ 7
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:BIT 0: When set to 1, motion direction of the 1 st spindle must be reversed;
BIT 1: When set to 1, motion direction of the 2 nd spindle must be reversed;
BIT 2: When set to 1, motion direction of the 3 rd spindle must be reversed;
Only valid when output command format of the spindle is in pulse format.
240 1ST SPD POS GAIN AT ORIENTATION
Range: 0 ~ 20000
Active: Active After RESET
Level: Machinery Builder
Default 30
value:
Unit: 1/S
Description When the spindle’s command format in control mode is V command (parameter
:
No. 0190 = 3), this parameter sets the spindle’s proportional gain during
positioning.
241 1ST SPD POS GAIN AT RIGID TAP
Range: 0 ~ 20000
Active: Active After RESET
Level: Machinery Builder
Default 30
LNC Technology Co., Ltd. 187